940guy
Active member
- Joined
- Apr 18, 2007
- Location
- Waxhaw, NC
I followed the below instructions and have the lc1 wired up correctly. but i am getting a reading that hovers around 10.2
Anyone have something i can try setting on the lc1 are defaulted for wideband.
Anyone have something i can try setting on the lc1 are defaulted for wideband.
MS2/Extra:
With your TunerStudio project open, go to:
File > Project > Project Properties and click on the Settings tab
Under EGO O2 Sensor, chose the right option (Innovate LC-1 Default) for your wideband in the drop down menu and click Ok. TunerStudio will quickly restart and take you back to the main dashboard.
Next, click on the Basic Settings tab and chose EGO Controls. You will need to change your EGO Sensor Type to wideband or dual wideband as appropriate for your setup. Don't forget to burn the change to your MegaSquirt. Lastly you will need to go to the Tools menu up top and click on Calibrate AFR Table. Chose your sensor type (Innovate LC-1 Default) in the drop down menu, and click on Write to Controller. This is a one way flash, so don't be alarmed if your settings don't 'stick' in this menu after you've sent them to the controller. After the write is complete, click Close.
Your AFR Targets Table will be under Basic setup > AFR Table 1