Turbobricks Forums

Turbobricks Forums (https://forums.turbobricks.com/index.php)
-   projects & restorations (https://forums.turbobricks.com/forumdisplay.php?f=22)
-   -   Question For the Turbo LS 24X Swappers (https://forums.turbobricks.com/showthread.php?t=355487)

2JZFC 06-16-2020 12:18 PM

Question For the Turbo LS 24X Swappers
 
Is anyone using or considered the Hooker LS turbo manifolds setup?

https://www.speedwaymotors.com/Hooke...ld,320377.html

JohnMc 06-16-2020 12:22 PM

240 series, or 24X vs. 58X? (heh)

I looked at them briefly, but (without ever trying to fit anything) thought that I'd have fewer issues with the steering going forward with the crossover pipe. Also, not much room going back down and out with the downpipe if you're not doing a fender exit. A crossover pipe coming up would take up room you might need for the downpipe.

In retrospect - something cast iron and spark plug access friendly would probably have been a better choice.

MikeSr. 06-16-2020 12:36 PM

Nice setup- a/c compressor would have to be removed or relocated.

2JZFC 06-16-2020 09:05 PM

Yeah, it seems the crossover pipe would definitely cause a clearance issue with the DP, especially if it's 4" or 3.5". MOF, for me, room for a DP is one of the drawbacks of this swap, probably because I am not a fan of the DP routed high against the strut tower. Fender exit is an option and I have one on a street-driven drag fox body but it just doesn't seem appropriate for a Volvo ;-)

JohnMc 06-16-2020 10:05 PM

The suspension/crossmember is limiting the forward placement of the DP, and there's a starter there as well, eating up room. Seeing how snug my DP was in that area, I can't imagine where a crossover coming up would fit in there as well.

I actually used some 3" oval piping in that area. Round from the turbo, high past the strut tower and over the headers, then to 3" oval as it dropped down by the motor into a 90 degree bend, then back to 3" round. And even then with it heat wrapped, I had to add a sheet metal heat shield to the starter.

vwbusman66 06-17-2020 08:37 AM

Denmah approved:
https://fahlersp.com/products/c-t4-t...ed-small-block

cosbySweater 06-19-2020 04:19 PM

I used the hooker turbo manifolds on my gremlin. The crossover didn't fit so I made my own but they are a nice piece. I'd say though the provided crossover probably will not fit on a 240. It's pretty wide


All times are GMT -4. The time now is 03:27 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.