• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

OEM Fuel line to FPR ?

Was just looking for something else in my bookmarks & I came across this -
https://www.jegs.com/i/Earls/361/9894DBH/10002/-1
I'm pretty sure that fits on the fuel rail where you showed in your photo.
I'd bookmarked this from a similar thread some time ago so the details are pretty fuzzy - perhaps someone else can remember?
Tim

The Volvo hard plastic line has a "ball" fitting - and the mating surface in the rail is also spherical - you've not going to find it at Summit, Jegs. etc.

It's possible Bellmetric could have it - you will need to measure the OD of the male thread & get the pitch to determine if someone carries the metric FI fittings used by Volvo & other European manufacturers back in the 80's-90's era
 

Here?s the fitting for the rail that you need. Will require high pressure fuel hose clamps as it?s a barb?d fitting.

With regard to using a female thread and male cone conversion fitting:
I tried the m14 male flare fitting adapter on the rail. While it threads on just fine, it does not seal. The female cone on the rail is a lot deeper (and possible different angle) that the male cone on the conversion fittings.
 
Back
Top