motarr mounts and such..

for my vertical mounted 16v b230, right now its just a b21 for mock up.
droping the pan without droping the x member will be a nice feature.
<a href="http://s265.photobucket.com/albums/ii234/2fast242gt/?action=view&current=003-14.jpg" target="_blank"><img src="http://i265.photobucket.com/albums/ii234/2fast242gt/003-14.jpg" border="0" alt="Photobucket"></a>
drivers side going thew a mess of PS and lines, its clears everything perfect though!
<a href="http://s265.photobucket.com/albums/ii234/2fast242gt/?action=view&current=002-16.jpg" target="_blank"><img src="http://i265.photobucket.com/albums/ii234/2fast242gt/002-16.jpg" border="0" alt="Photobucket"></a>
passenger side.
<a href="http://s265.photobucket.com/albums/ii234/2fast242gt/?action=view&current=001-17.jpg" target="_blank"><img src="http://i265.photobucket.com/albums/ii234/2fast242gt/001-17.jpg" border="0" alt="Photobucket"></a>
the washer and nut are being used as spacers right now, the fatory bolts are to long with the new mounts. they are bolted down tight on a few bolts. it looks like its gona be a fun setup, im ecited!

Wait, are you selling these?

i think straight up 16vt will help a lot in the narrow 240 bay, it's how i'd (try) and do it

NotSoFresh said:

Wait, are you selling these?

Click to expand...

would love to. maybe a set or so dont hound me with pm's people this was a side project i did at school, as is i have very little time if i get time ill try and cut a few extra sets on the water jet. these could also be used in the slanted configuration. just weld the arm at a diffrent angle.

Lookin' good.

I have mocked up and sourced all the parts to do a similar passenger mount.


There is a hole in the pseudo frame rail just above where the k-member. All I can gather is there is indent from a bracket that bolts through the k-member from below and maybe this "hole-window" is for alignment purposes? Does it serve any other function? Can it be covered when making a weld-on bracket without issue? Thanks.

jmc0369 said:

I have mocked up and sourced all the parts to do a similar passenger mount.


There is a hole in the pseudo frame rail just above where the k-member. All I can gather is there is indent from a bracket that bolts through the k-member from below and maybe this "hole-window" is for alignment purposes? Does it serve any other function? Can it be covered when making a weld-on bracket without issue? Thanks.

Click to expand...

That window is to locate the alignment stud on the member. Also you'll want to make both mounts not just one, i made two for this project. along with modifying your oil pump