View Single Post
Old 12-08-2008, 07:10 PM   #26
Board Member
Join Date: Oct 2003
Location: Finland

Originally Posted by JW240 View Post
a lot of stuff is possible i guess, but it is extremely hard to figure out certain stuff since Bosch gives no details about this stuff. It is all reverse-engineered. Step by step!

No need to figure out, chip has one control pin, depending where it its connected it ether reads first or the second half of the chip, you can do it pretty easily with couple of wires and a switch, this case it would be easy to
ad it on board, so no need to twist chips pin.

edit: actually its easy to do with the chip socket, no need to change layout...

Last edited by JR-66; 12-08-2008 at 07:19 PM..
JR-66 is offline   Reply With Quote