View Single Post
Old 06-16-2020, 10:05 PM   #5
PV Abuser
JohnMc's Avatar
Join Date: May 2004
Location: St. Louis

The suspension/crossmember is limiting the forward placement of the DP, and there's a starter there as well, eating up room. Seeing how snug my DP was in that area, I can't imagine where a crossover coming up would fit in there as well.

I actually used some 3" oval piping in that area. Round from the turbo, high past the strut tower and over the headers, then to 3" oval as it dropped down by the motor into a 90 degree bend, then back to 3" round. And even then with it heat wrapped, I had to add a sheet metal heat shield to the starter.
'63 PV Rat Rod
'93 245 16VT Classic #1141
JohnMc is offline   Reply With Quote