home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > performance & modifications

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-09-2019, 02:05 AM   #1
hessam69
Board Member
 
Join Date: Jun 2009
Location: Sydney, Australia
Default Shaving the head for bigger bangs

Quote from stealths page:

I have long believed that to remove material from the deck surface in amounts greater than the absolute minimum needed to restore flatness was not wise; whether the head be iron or aluminum. As a result of this forced, but not unwelcomed or regretted, excercise and investigation; my bias against such material removal has only intensified: to "shave a head" to raise compression ratio, especially on an aluminum head, is very ill-advised; and to do that on an aluminum head used in a boosted motor is, as I have come to see things, a very stupid and counterproductive idea....if you are concerned with longevity and durability.

This goes against John Vanlandinghams idea that you should shave 1.5mm off the head.

So who's right?
hessam69 is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 04:28 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.