2turbotoys
Salaminizer
- Joined
- Nov 13, 2007
- Location
- Reading pa
I followed the procedure in Section 2 Group 24 Fault tracing Oxygen sensor feedback system, its the only one that has electric tests starting on page 6.
D1: Grounds are connected
D5: I do not have power to terminal 8 so go to F1
F1: No voltage at either terminal
F2: Voltage present
F3: Voltage, but only 6.4 mv
F4: Voltage across both terminals, only 0.9 mv but if its still voltage I guess
Diagnosis according to the results of this test are defective relay.
Sound about right? I'll start looking though my boxes of relays for another haha
D1: Grounds are connected
D5: I do not have power to terminal 8 so go to F1
F1: No voltage at either terminal
F2: Voltage present
F3: Voltage, but only 6.4 mv
F4: Voltage across both terminals, only 0.9 mv but if its still voltage I guess
Diagnosis according to the results of this test are defective relay.
Sound about right? I'll start looking though my boxes of relays for another haha