Holset hx35 oilfeed line

[Mr.Borrie]

Can anyone tell me the oil feed line size I need for my hose.
The one off my Cosworth is to small, bonus points for link to an adapter I can use to reuse the garret cossie line


Photo:

[WTF99]

An4 ans AN10 or better AN12

[Mr.Borrie]

Its an npt size I think ..?

[Stiggy Pop]

Originally Posted by Mr.Borrie

Its an npt size I think ..?

the oil inlet is m12x1.5

I'd run a -6 AN hose size for the feed and a -12 AN hose for the drain. Fitting that big drain hose is tough if you have a snaky header.

[Mr.Borrie]

Originally Posted by Stiggy Pop

the oil inlet is m12x1.5

I'd run a -6 AN hose size for the feed and a -12 AN hose for the drain. Fitting that big drain hose is tough if you have a snaky header.

Yes I got the return line AN12 with yoshifab block thingy

[MasterCylinder]

Yoshifab should be an-10.

[Mr.Borrie]

Originally Posted by MasterCylinder

Yoshifab should be an-10.

Ah yes you are right

[Mr.Borrie]

Originally Posted by Stiggy Pop

the oil inlet is m12x1.5

I'd run a -6 AN hose size for the feed and a -12 AN hose for the drain. Fitting that big drain hose is tough if you have a snaky header.

Going this way, is the block size also m12x1.5 so I can order the couplings for that side too?


Edit: it’s m14x1.5