• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Information needed on particular B30 intake and exhaust manifolds

TGB1314A

New member
Joined
Aug 25, 2019
Location
Sheridan, Oregon
Hello to all,
It has been far too many years since I have been on this forum. I am searching for information on specifically which model/years the particular combination of the separate B30 aluminum intake manifold and two piece exhaust manifold was used. The intake used the twin side draft Zenith-Stromberg 175CD-2 carbs of a typical B30A motor. Application will eventually be on a 1975 Volvo TGB1314A and a 1977 Volvo AluZn TGB11.
Thank you!

Jim Molloy
Waldersee Farm
http://www.northwestmogfest.com

photo.php
 
AFAIK, all carb'd B30's used in 164's had a unified cast iron intake/exhaust manifold. When the 164's went to fuel injection in '72 they used an aluminum intake and 2 separate exhaust manifolds.

164IntakeExhaust.jpg
 
Looks like a very rare part that you will definitely have to get from Sweden. It wouldn't flow any better than the cast iron one normallly used. Just looks like the runners are shorter for clearance in the truck.

probably get better performance from the Penta setup referred to in this thread. If you are lookng for performance.
 
Back
Top