Shinchan
Member
- Joined
- Jun 28, 2018
- Location
- Lafayette, CO
Will a 3-inch diameter drive shaft fit into the tunnel on a '72 140? Trying to figure out if I can use a stock Mustang drive shaft without it rubbing on the tunnel.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
Lowered? I?d imagine any one piece driveshaft is going to rub if the car is any lower than stock.
It'll be lowered 40mm. I'll probably shorten the seat belt bolt ans see what happens.
You want to run a ~2" 2-piece driveshaft. Going with the single piece 3" is not going to work.