• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Holset hx35 oilfeed line

Mr.Borrie

The Sneaky F*ing Ukrainian
Joined
Aug 1, 2006
Location
Netherlands
Can anyone tell me the oil feed line size I need for my hose.
The one off my Cosworth is to small, bonus points for link to an adapter I can use to reuse the garret cossie line


Photo:
picture.php
 
Last edited:
the oil inlet is m12x1.5

I'd run a -6 AN hose size for the feed and a -12 AN hose for the drain. Fitting that big drain hose is tough if you have a snaky header.

Going this way, is the block size also m12x1.5 so I can order the couplings for that side too?


Edit: it’s m14x1.5
 
Last edited:
Back
Top