2turbotoys
Salaminizer
- Joined
- Nov 13, 2007
- Location
- Reading pa
I see no reason why it could be a problem. I didn't ask anyone about it since I don't know anyone else who has done that. Of course there will be a washer to clamp a little better. It tightens down fine, so I think it is all good.
You could just oval the hole out, but this was a lot faster and easier.
I really didn't want to use a cast iron GM style master cylinder as they are no fun to bleed and they look ugly.
You could just oval the hole out, but this was a lot faster and easier.
I really didn't want to use a cast iron GM style master cylinder as they are no fun to bleed and they look ugly.