• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

pre-90 exhaust manifold depth?

oldschoolvolvo

Well-known member
Joined
Mar 27, 2004
Location
Lancaster, PA
Anyone have the measurement between the exhaust port flange and the turbo mounting flange on a pre-90 manifold? Is the measurement the same or different than a 90+ manifold?
(I imagine the measurements are close to the same, but if someone could measure it that would satisfy my curiosity :))

CNX0NIe.png
 
I've been thinking about doing this for a couple months now so thanks for the motivation.
I get 2-1/8" on the pre -90 and 2-3/8" on the 90- I have lying around. Plus/minus 1/16"

Measurement not mega-accurate, but close. I laid the exhaust ports flat on a countertop with the bulge of the manifold hanging over the edge, clamped the flattest board I have across the mounting flange, and measured down to the countertop. The step on the flange for mounting a factory turbo is not included in that measurement, I am measuring to the flange itself with the studs.

Hope that helps some.
 
Back
Top