• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

3D printed "+ Turbo" badges

A

autoloclys

Member
Joined
Dec 20, 2016
Location
Boston MA
ive had this idea for a while since I +T'd my 240 wagon.

original 240 turbo badges are very $ on ebay or on here, and i ended ebaying a 760 turbo badge and cutting it up to put turbo badging on my tailgate. I always kind of wanted to have a +Turbo badge though, just to rep the fact that its not a factory version, and also kinda wanted a proper 240 badge since the font on the 700 and 900 badges is different.

so i finally had some time in solidworks and printed one last night. I started out trying to just make a "+" to match the 700 badge i have, then went all in on the proper 240 font.

voila!

https://photos.app.goo.gl/MoahA6m4DDj32SEx9
 
someone tell me what the right overall dims are and the spacing on all 4 sides from the lettering to the edge

https://photos.app.goo.gl/8vjDxKzaV5DZJkS27

8vjDxKzaV5DZJkS27
 
turbo front grill badge dimensions

OK here is what I measured.
Overall dimensions
3 3/4" wide.
1 1/16" high.

Lettering
Left side to the upper bar of the T is 3/8".
Right side to the O is 3/8".
Top down to the bar on the T and to the vertical tip of the B is 1/4".
Bottom up to the lower edge of all letters is 1/4".


Hope that helps. Looks good!
 

Attachments

  • 100_0676v2.jpg
    100_0676v2.jpg
    48.9 KB · Views: 202
link on the first post is to a google photos album, there are photos of the actual badges im printing. for some reason i cant embed pics from google here, and I dont have other hosting options.

I started a thread in the for sale section
 
You must log in or register to reply here.
Back
Top