BeaverMeat
Active member
- Joined
- Aug 8, 2020
- Location
- Vancouver Island
Welp... down the rabbit hole I go.
Swapping the rear axle on the Volstang is starting look like a ?while I?m there? type of job and the list of parts is starting to pile-up.
Going with the IPD treatment... would really like to go with Kaplhenke or Yoshifab parts but, I had to convince myself many times ?I?m not racing it?
So... IPD panhard and torque rods. That?s pretty much cut and dry. I?m also boxing the trailing arms.
A few questions to that regard.
Haven?t decided if I?m going to refurbish a set of used trailing arms or just buy some new cheap Dormans. Would like to just buy the Yohifab plates unfortunately that?s going to cost me extra cash to ship them to the north yonder. Is there a set of instructions on fabricating plates and boxing the trailing arms? Something I can give to the fabrication shop.
Bushings! What?s the best way to go with the trailing arm bushings? OE rubber or polyurethane or is there something else?
Swapping the rear axle on the Volstang is starting look like a ?while I?m there? type of job and the list of parts is starting to pile-up.
Going with the IPD treatment... would really like to go with Kaplhenke or Yoshifab parts but, I had to convince myself many times ?I?m not racing it?
So... IPD panhard and torque rods. That?s pretty much cut and dry. I?m also boxing the trailing arms.
A few questions to that regard.
Haven?t decided if I?m going to refurbish a set of used trailing arms or just buy some new cheap Dormans. Would like to just buy the Yohifab plates unfortunately that?s going to cost me extra cash to ship them to the north yonder. Is there a set of instructions on fabricating plates and boxing the trailing arms? Something I can give to the fabrication shop.
Bushings! What?s the best way to go with the trailing arm bushings? OE rubber or polyurethane or is there something else?