Swedbrick
Active member
- Joined
- Oct 12, 2016
- Location
- Netherlands, Source of Grolsch
Since I'll be upgrading the brakes on my 7-series to a set of XC90 T6 ones, for which I'll also be designing the brackets, dust shields and e-brake adapters, I created this tread for reference to anyone looking to do the same.
The setup I'll be working with 336mm rotors front, 308mm rotors rear
These are vented both rear and front
The front shown here with the ruler of a total width of 36cm
The rear as well
The fitment with the wheels I'll be running also shown below, these are 17 inch Revolution Motorsport Millenium Rally wheels, with a stepped inside barrel to allow for bigger brakes
The setup I'll be working with 336mm rotors front, 308mm rotors rear
These are vented both rear and front
The front shown here with the ruler of a total width of 36cm
The rear as well
The fitment with the wheels I'll be running also shown below, these are 17 inch Revolution Motorsport Millenium Rally wheels, with a stepped inside barrel to allow for bigger brakes
Last edited: