KoduKoer
New member
- Joined
- Aug 29, 2018
- Location
- Tartu, Estonia
I am burdened with the hellish task of fitting a small 1.9L whiteblock into my 940 diesel.
I have the engine and tranny in place and am about to start creating necessary engine mounts. When mounting the M90 to the engine, I noticed that bolt holes on the tranny line up with the engine block like they should, but wont line up with holes on the T4 oil pan.
Any advice on how to solve it? Do I even need to solve it?
Other thing that is concerning me is the drive shaft. Since the M90 is shorter than M46, the front section of the shaft will not reach.
Is the easiest option here to weld the two together?
I am apologise for any questions that might be too stupid, but I really want to get this thing done and will not hesitate to ask for advice.
Thank you
I have the engine and tranny in place and am about to start creating necessary engine mounts. When mounting the M90 to the engine, I noticed that bolt holes on the tranny line up with the engine block like they should, but wont line up with holes on the T4 oil pan.
Any advice on how to solve it? Do I even need to solve it?
Other thing that is concerning me is the drive shaft. Since the M90 is shorter than M46, the front section of the shaft will not reach.
Is the easiest option here to weld the two together?
I am apologise for any questions that might be too stupid, but I really want to get this thing done and will not hesitate to ask for advice.
Thank you