Dirty Rick
Active member
- Joined
- Apr 10, 2013
- Location
- Cornholio, OR
"Jury is still out if the center point of tubes will fit under the hood, we'll have to see."
Cut the point flat and plate it. Gusset the bottom as needed.
Don't weld any of the stuff yet, I'll bet you change it to fit around the intake.
In fact they both will need to get worked to fit around each other.
Or you can just cut a hole in the hood and do it "Weld Er Up" style! ;^)
Cut the point flat and plate it. Gusset the bottom as needed.
Don't weld any of the stuff yet, I'll bet you change it to fit around the intake.
In fact they both will need to get worked to fit around each other.
Or you can just cut a hole in the hood and do it "Weld Er Up" style! ;^)